Noise Curtains

by dB Engineering


Mounting Options

Edge Details

dB Engineering offers a variety of edge treatments to accentuate your design and allow for customization and uniqueness.

details.jpg (6863 bytes)

detail.gif (3789 bytes)

*Other edge details available.

 

Mounting Options

Several options are available for mounting, depending on your needs and situation.   Installation instructions are included with each shipment.
option1.jpg (3068 bytes) Mounting Adhesive
Construction adhesive is applied to the back of each panel.   Panels are placed in the desired location.  Temporary support is required to avoid slippage.

 

 

option4.jpg (6646 bytes) Mechanical Clips
The panel clips are mounted onto the panels at the time of shipment.  The wall clips are installed on the wall at the location established by the position of the panel clips
option2.jpg (7861 bytes) Hook and Loop Fasteners
The loop side of the fastener is applied to the panel at time of shipment.  The hook is attached to its mate and when installing, the tape backing is removed and the panel is positioned on the wall.  Permanent support is required.

 

option5.jpg (5941 bytes) Concealed Splines
Panels with concealed spline attachments are provided with kerfs along the edges of the panels.  The spline then inserts into one panel and is mounted onto the wall.   Adjoining panels are inserted into the remaining half of the spline.
option3.jpg (7347 bytes) Impaling Clips
Impaling clips are mechanically mounted to the wall.  The panels are then set into the impaling clips.  Adhesive is used for additional support.

Table showing how the human ear perceives noise reduction.

Decibel Reduction Reduction Experienced by Ear
2 15%
4 23%
6 38%
8 48%
10 56%
12 63%
14 68%
16 75%
18 77%
20 81%